My Sunrise

    • Contact Sensor

    Function overview

    • The Contact Sensor monitors the opening and closing of doors or windows.

    • The larger sensor is mounted on the fixed frame, while the smaller magnet is attached to the moving part (door/window).

    • When the door or window opens, the magnet separates from the sensor, triggering an internal magnetic switch that sends an alarm signal to the base station.

    • The Contact Sensor also communicates signal problems and low battery conditions.

    LED indicator

    In normal operation, the LED remains off except in the following cases:

    • The LED flashes when the Contact Sensor is triggered if battery status is low.

    • To confirm signal transmission, the LED flashes twice rapidly and stays on for 1.5 seconds once the base station has acknowledged the signal.

    Battery

    • Uses 1 × 3V CR2032 lithium battery

      Battery status is reported to the base station via regular monitoring signals.

    • Low battery → app message + optional push notification, call, SMS, email

    • Battery replacement:

      1. Loosen the screw at the bottom of the sensor.

      2. Turn the device over and gently open the back cover with a flat-head screwdriver.

      3. Remove the old battery, wait 10 minutes, press the LED button five to six times to discharge residual power.

      4. Insert a new battery (+ side up).

      5. Re-attach the cover and tighten the screw.

    Installation
    1
    Switch on

    Remove the battery insulator → LED flashes for 30 seconds (warm-up phase). The sensor is now ready for use.

    2
    Registering with the app

    Follow the instructions in the app to add the Contact Sensor.

    3
    Alternatively: Add the Contact Sensor manually.

    1. Put base station in pairing mode (press Reset/Learn for six seconds until LED flashes blue).

    2. Success = One beep from base station

    NOT AVAILABLE

    Tip

    Give each sensor a unique name for easy identification.

    4
    Placing/Mounting the Contact Sensor

    • Mount the Contact Sensor on the fixed door/window frame, and the magnet on the moving part (door/window).

    • Maximum distance between magnet and sensor when door is closed: 15 mm.

    • Mount using screws/wall plugs or the included double-sided adhesive pad.

    Congratulations! The installation of your Contact Sensor is complete.

    Button functions

    Test button, Learn button

    LED display

    Colour: blue

    Power source

    1 x 3V CR2032 lithium battery

    Battery life

    3 years (actual battery life may vary depending on settings, the environment and usage)

    Low battery threshold

    2.3 V

    Protocol / frequency

    Proprietary 868 MHz

    Range

    920 metres in open space

    Operating temperature

    –10°C to +45°C

    Operating humidity

    85% relative humidity @ 23°C (non-condensing)

    Dimensions

    Contact Sensor: 57.8 x 28.1 x 10.1 mm Magnet: 57.8 x 14.9 x 9.2 mm

    Weight

    Contact Sensor: 9.5 g (battery excluded) Magnet: 10.0 g