Solar Panel
?w=256&q=75)
Key features
The Sunrise Solar Panel (SOL-SR1) is designed to keep your Sunrise Outdoor Camera continuously powered by collecting sunlight. It provides a reliable, eco-friendly power source, reducing the need for manual charging. For best performance, follow the installation and maintenance instructions below:
High-efficiency Solar Panel: Converts sunlight into power for your Outdoor Camera.
Universal joint: Allows flexible up/down and left/right adjustment for optimal sun exposure.
Socket nut: Secures the universal joint to the Solar Panel.
Locking screw cap: Fixes the universal joint to the Base.
Base and wall anchors: Attach the universal joint to the wall.
3m USB-C cable: Provides flexible placement in relation to the camera.
Important recommendations
General
Wipe the Solar Panel regularly using a soft, damp cloth to remove dust and debris.
Avoid abrasive cleaners that can scratch the panel surface.
After storms or snow, ensure the panel is not covered or obstructed.
Always ensure the cable remains undamaged and properly connected.
Location
Place the Solar Panel in an area with consistent sunlight throughout the year.
The panel needs only a few hours of direct sunlight per day, but more sunlight improves charging performance.
Avoid shaded areas caused by roofs, trees, or seasonal sun changes.
Weather, season and geographic location affect charging efficiency.
The charging cable is 3 metres long, allowing flexible placement relative to the camera.
Installation
Have you got everything?
Before you start the installation check whether your package contains the following items:
Solar Panel with 3m USB-C cable attached
Universal joint
Socket nut
Locking screw cap
Base
4 screws with 4 wall anchors
Quick Start Guide
Hold the base against the wall in the desired location.
For hard surfaces (brick, concrete):
Pre-drill a hole using a 6 mm drill bit, insert a wall anchor, and attach the Base using the provided screws.
Insert the universal joint into the locking screw cap.
Screw the socket nut onto the universal joint.
Attach the universal joint to the back of the Solar Panel and tighten firmly.
Screw the universal joint (with panel attached) into the base by screwing the locking screw cap on top.
Ensure the joint is angled upward before tightening. The Solar Panel's tilt angle can be adjusted up to 90°.
?w=1024&q=75)
Loosen the locking screw cap to adjust left/right, then tighten again.
Angle the Solar Panel upward by approximately 30°.
In the northern hemisphere: point the panel south. In the southern hemisphere: point the panel north.
Ensure all locking components are firmly secured after installation.
Plug the Solar Panel's cable into the USB-C charging port of the camera.
Ensure the cable runs safely along the wall without creating tripping hazards.
?w=64&q=75)
Safety information
The product is only suitable for use in a temperate or subtropical climate.
Use the product only at a temperature between -20°C and 40°C and a relative humidity of up to 100%.
Use the product in accordance with the installation and product documentation of Sunrise.
The product is not suitable for use by children and should not be considered a toy.
Do not attempt to dismantle the product as it can be dangerous and contains no parts covered by a warranty.
| Number of cells | 12 solar cells in series |
| Mount | Adjustable swivel |
| Contents | Solar Panel with USB-C cable attached, screws, masonary anchors, swivel |
| Wire length | 3m |
| Wire type | 13-core durable multi-core cable for power transfer |
| Minimum output power (@STC) | ≥2.8W |
| Standard operating voltage (@STC) | ≥5V |
| Standard operating current (@STC) | ≥570mA |
| Dimensions | 120.5 × 173.5 × 12.5 mm |